» There is an integrated potentiometer for setting the speed
» Two connection leads can be used to provide both a start/ stop and aclockwise/ counter-clockwise function
» By supplying an analog target voltage in the range 0...+10 V, thespeed of rotation can be set in a
range from 500 rpm to 5000 rpm
» Lower speeds, down to ca. 200 rpm, are possible where less smoothrotation can be tolerated
» Various protection functions, such as low-voltage cut-off, reversepolarityprotection, over-temperature cut-off,
and stall protection,guarantee high operational reliability
» A signal with 4 pulses (2x 2 pulses) per revolution generated from theintegrated Hall sensors will be provided
Please note: The connection between motor and electronics must beas short as possible.
The maximum length of the connectioncable should be not longer than 2m.
For avoiding ofany failures it is recommended to use a separated cablerouting for phase and sensor.
(Please note that, for the BGE 3004 A, the matchingmotor connector must also be ordered.)